XBee 3mW Wire Antenna – Series 2C
The XBee 3mW Wire Antenna is the XBee XB24CZ7WIT-004 module from Digi with inbuilt Wire antenna. Series 2C improves on the power output and range over standard Series 2 modules. Series 2C modules allow you to create complex mesh networks based on the XBee ZB ZigBee mesh firmware. These modules allow a very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point networks are supported.
The XBee 3mW Wire Antenna – Series 2C module has essentially the same hardware as the older Series 2, but has updated firmware and higher power output.
Note: If you are looking for a simple point-to-point configuration, you might want to try the Series 1 instead.
Note: Series 1 and Series 2C XBee modules have the same pin-out. However, Series 1 modules cannot communicate with Series 2C modules.
Features of the XBee 3mW PCB Antenna:
- 2.1V to 3.6V supply at 33mA
- 250 Kbps data rate
- 3mW output (+5dBm)
- 6.3mW (+8 dBm), boost mode
- 4000ft (1200m) range
- Built-in pcb antenna
- Fully FCC certified
- 6 10-bit ADC input pins
- 8 digital IO pins
- 128-bit encryption
- Local or over-air configuration
- AT or API command set
Documents relating to the XBee 2mW PCB Antenna: